Buffalo Tools BB07552 Instruções de Operação descarregar pdf (Página 6)

BB07552 5 Inch Double Cut Saw Assembly & Operating Instructions

REPLACING THE CUTTING WHEELS

Improper installation of the cutting wheels can cause injury to the user or damage the cutting saw. Use caution when

removing and installing cutting wheels. Make sure nuts are tight and secure before use.

Check to be sure the tool is unplugged.

Press the spindle lock (Figure E)

Use the Multi Purpose Wrench to remove Bolt (Figure F)

Rotate the Wheel Guard, then remove the cutting wheels from the tool (Figure G)

To replace the cutting wheels, choose only Double (Twin) Cut Replacement Saw Blades Replace Wheel (available from your local dealer

or by calling our Customer Service department). Select Wheel A first, by positioning it along the three alignment holes. (Figure H), then

position Wheel B along the two alignment holes (Figure I)

When both wheels are locked in place, replace Bolt (Figure F) and tighten securely.

OPERATION

IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE, DO NOT

OPERATE THIS PRODUCT!

Lift the tool off the work surface before starting and stopping the motor.

Applying too much pressure on the work surface while cutting can damage the saw.

Always secure the work piece using clamps. Never use your hands to hold the work piece in place. An unsecured work piece

could cause serious injury.

Plug into outlet. Hold firmly in hand and press the Power On/Off trigger switch to start the motor. Follow the directions below for cutting

details and feed speed suggestions.

(Figure E)

(Figure F)

(Figure G)

(Figure H) (Figure I)

1 2 3 4 5 6 7 8 9 10

Sem comentários

Buffalo Tools BB07552 Instruções de Operação Página 6